Airsoft Sniper Forum banner

G&G Valve knocker placement?

1512 Views 1 Reply 1 Participant Last post by  toomanybbs
Ok, so I ordered this piece for my tanaka m700:
It came and I took my mag apart to the point where I could remove the stock valve knocker, and the new piece doesn't fit. Am I doing something wrong? Does it go there(in the back of the mag)?
Thnx in advance

Pic is uploaded. Piece on top is the G&G part.
1 - 2 of 2 Posts
Installed all the pieces I ordered and its looking good :).
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.