Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
890 Posts
Discussion Starter · #1 · (Edited)
I bought a g&p m170 motor awhile ago and just got around to putting it into the gun.

For whatever reason it won't turn over inside the gearbox.
here are the things I've tried:

ran it outside the gun (pass)
ran it inside the gb just gears (failed)
ran it without gears inside the GB (pass)
ran it with just the bevel gear (failed)

I've adjusted the motor height and even then it wouldn't turn over until it released from the bevel gear.

Any thoughts of what I can try or do?
 

·
Registered
Joined
·
890 Posts
Discussion Starter · #4 · (Edited)
The motor was new and had never been used before a few days ago other then a dry rotation test.

Unfortunately when I try motors without the spring and piston I take out the AR latch as well so I can listen for grinding.So even if it was spinning in the wrong direction the gears should rotate regardless.

Note: this gb is known to work with my g&p m120 motor without problems.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top