Airsoft Sniper Forum banner
1 - 2 of 2 Posts

· Premium Member
Joined
·
2,311 Posts
Sorry, I haven't checked in a little while...

How fast was the drill spinning?

If it was too slow, you could have put too much pressure on the mag itself and cracked it, or if it was too fast, it could have stressed the metal through heat. You really need to do it at extremely high speed with cutting fluid.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top