Airsoft Sniper Forum banner
1 - 20 of 23 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter · #1 ·
Hey guys, I found myself coming back after some really bad experience as assault, support, and that stuff. So, I need help getting a new rifle. I'm leaning towards gas but don't know much about them. If you can help me out it would be greatly appreciated.
In the past I have had a JG bar-10, TM l96 AWS, UTG l96, and about 5 DMR's.
 

·
Registered
Joined
·
323 Posts
What's your budget like? You can get a UTG Type 96 to shoot very well with mostly DIY mods and very minimal aftermarket upgrades if any.
Except the UTG Mk96 desperately cries for a $150-200 trigger for high FPS :lame:
 

·
Registered
Joined
·
126 Posts
Discussion Starter · #12 ·
Ok, so I guess I'll have to build an HPA rig then. Well I have 6 or 7 months to do it. Wesley even though you can get a UTG Type 96 to 500-550 FPS, the stock trigger box will start to crack and eventually break.
 

·
Registered
Joined
·
2,199 Posts
Propylene is a by-product of toxic alcohols. Do you mean Propane? That is green gas, just minus some lube and perfume.
Actually minus lube and added stench so you can tell if it's leaking. :hehe:

Trigger mech can be got for cheaper than $200 mate. THheres the PDI one for $70
the cheapo metal one for $30 or a replacement plastic one fro $15

:tup:
 

·
Registered
Joined
·
323 Posts
The only problem are the VSR-10 conversion chambers; people usually have problems with them due to the G96's nozzle not being removable.
I actually haven't had an issue with this yet. I'm using the stock nozzle with the conversion kit, and I haven't run an FPS test but it feeds and fires just fine.
 
1 - 20 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top