Airsoft Sniper Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
283 Posts
hoggie said:
How would I get it onto my APS-2. I have zero idea how this would work. I've seen people with it on there, but I am not sure how they did it.
It's actually rocket science.

You need a stud mount on your gun first, then you can attach the bipod.
 

·
Registered
Joined
·
1,033 Posts
You can find a sling stud kit at gun shops and sporting goods stores that have a hunting section. Yes you have to dill, but its not all that hard.
 

·
Registered
Joined
·
3,975 Posts
Your APS-2 doesn't come with a front sling mount?

If not go and get one, then look at the bi-pod. You see those little fingers that stick up through the bottom of the pod? There are little pins on each of those fingers. Those are what go into the sling stud. When those are in the holes, go to the other side of the pod, and turn the thumb wheel. Turn until snug.

Open and close the pod a few times, as you may have to re tighten the thumb screw. After that....you are good to go
 

·
Registered
Joined
·
745 Posts
Discussion Starter · #7 ·
woogie said:
Your APS-2 doesn't come with a front sling mount?

If not go and get one, then look at the bi-pod. You see those little fingers that stick up through the bottom of the pod? There are little pins on each of those fingers. Those are what go into the sling stud. When those are in the holes, go to the other side of the pod, and turn the thumb wheel. Turn until snug.

Open and close the pod a few times, as you may have to re tighten the thumb screw. After that....you are good to go
Yes, it does. I am just really unsure what I am suppose to do with it. Rofl. I am losing my Mr. Fix it touch x.X
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top