Airsoft Sniper Forum banner

Homemade Lens Protector

5441 Views 4 Replies 3 Participants Last post by  Geli
Hey fellow snipers,

I just wanted to demonstrate how you can make inexpensive scope protectors for scopes/red dots. This mod costs less than $10 and is completely reversible if you are not satisfied with the results. The material required includes:

-Clear Lexan (Comes in varying sizes: 1/16,1/8, etc)
-Black Hockey Tape
-Original Scope Cover (Optional)

Step 1:

Place the objective lens flat on top of the lexan. Then take your pen and trace the outer circumference of your scope.

Step 2:

Cut along the lines you traced with a pair of scissors. Then place the circle on the objective lens. If the lens does not fit, trim the circle with your scissors.

Step 3:

Peel only half of the roll of hockey tape.

Step 4:

Peel off the blue cover on the lexan lens and place on the objective lens. Then attach a strip of hockey tape to the scope and to the lexan. Make sure a thin strip of tape sits on top of the lexan.

Hopefully this tutorial will help save some $$$ and protect your expensive scope.

Geli out!
See less See more
  • Like
Reactions: 1
1 - 1 of 5 Posts
If you make the protector 2-3mm smaller in diameter it would it in the end of the scope cap. So unscrew the end of the scope off and fit the plastic protector in there. No need for taping it on. This is what I do.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.