what kind of problems do you foresee? If you think I'd have a hard time getting to the mags, how would putting them under a ghillie fix that?
Hoping you guys could help with a loadout
Alright, I'm currently saving up for a Kokusai Crimebuster, for those of you who don't know what that is, it's a classic airsoft NBB, incredibly efficient and consistent setup. When Booster tunes them they are accurate out past 350' at 550 FPS (.2 chrono, .4 in operation) and reports have been made of out past 450'.
In the following loadout I have organized everything that I think I will need and have found the items I think best fit my needs. I know that this loadout is basically overkill, but I think the name speaks to my view on that. If you guys could just go over the practicality of this and shoot me down if I am wrong I would be much abliged.
On to the good stuff:
It is an HPA gun, so I'll be using a Crossfire tank:
http://www.crossfireinc.com/products.asp?cat=29
Reg system will be bought from Austinwolv on the classicairsoft forums, very reliable two reg system, might ask for a valved main reg to depressurize the system after use.
http://classicairsoft.org/forum/showthread.php?9002-WTS-Pre-assembled-dual-reg-gas-rigs
Grimlocs to hold lines to web gear:
http://www.tripleaughtdesign.com/Equipment/Clips/Grimloc-Carabiner
Two 90 degree panels to rotate tank pouch across lower back rather that directly up the back (lower profile): http://www.tacticaltailor.com/90degreepanel.aspx
Frag pouch to hold Secondary regulator: http://www.diamondbacktactical.com/product/Diamondback-Tacticalreg-Frag-Grenade-Pouch-Single,225,49.htm
Pouches to carry 3-4 mags:
http://www.octactical.com/ar20rndmag.html
PALS weapons catch (DBT if possible)
Pouches for two MP9 mags:
http://www.usgruntgear.com/hksubgunmodo.html
Throat Mic:
http://www.soundrite.biz/headset/nt3blkops2-description.html
(already have motorola Talkabouts for radio, need radio pouch)
The vest this will all be on:
http://www.grtgear.com/Products/GrandRiverTacticalVestSystems/LBV3/
This will all go over a ghillie (homemade over this summer) with jute/burlap tied into the molle and hairbands/rubber bands to tie in natural veg. This is where I am a little concerned. How do you guys think it will work running a vest over a ghillie, should I just ghillie up the arms and a little on the sides, leaving the middle open for the vest, or should I make a full crawl suit and just put the vest on over the jute?
The other thing is, if I'm going to sling the rifle at all, I will have to use a single point, as the forward sling mount isn't very strong. How will this work with transitioning to my planned secondary (KWA MP9R)? Should I plan on only using the MP9 when pinned down and unable to get out, in which case I wouldn't need a sling for the Crimebuster and the plan for engagement would be to drop the rifle, pull the MP9 off the weapons catch, and fire. If I got a single point sling, I could fire the MP9 while extracting, although that might not even work. What do you guys think?
Thanks for your help.
Sam
In the following loadout I have organized everything that I think I will need and have found the items I think best fit my needs. I know that this loadout is basically overkill, but I think the name speaks to my view on that. If you guys could just go over the practicality of this and shoot me down if I am wrong I would be much abliged.
On to the good stuff:
It is an HPA gun, so I'll be using a Crossfire tank:
http://www.crossfireinc.com/products.asp?cat=29
Reg system will be bought from Austinwolv on the classicairsoft forums, very reliable two reg system, might ask for a valved main reg to depressurize the system after use.
http://classicairsoft.org/forum/showthread.php?9002-WTS-Pre-assembled-dual-reg-gas-rigs
Grimlocs to hold lines to web gear:
http://www.tripleaughtdesign.com/Equipment/Clips/Grimloc-Carabiner
Two 90 degree panels to rotate tank pouch across lower back rather that directly up the back (lower profile): http://www.tacticaltailor.com/90degreepanel.aspx
Frag pouch to hold Secondary regulator: http://www.diamondbacktactical.com/product/Diamondback-Tacticalreg-Frag-Grenade-Pouch-Single,225,49.htm
Pouches to carry 3-4 mags:
http://www.octactical.com/ar20rndmag.html
PALS weapons catch (DBT if possible)
Pouches for two MP9 mags:
http://www.usgruntgear.com/hksubgunmodo.html
Throat Mic:
http://www.soundrite.biz/headset/nt3blkops2-description.html
(already have motorola Talkabouts for radio, need radio pouch)
The vest this will all be on:
http://www.grtgear.com/Products/GrandRiverTacticalVestSystems/LBV3/
This will all go over a ghillie (homemade over this summer) with jute/burlap tied into the molle and hairbands/rubber bands to tie in natural veg. This is where I am a little concerned. How do you guys think it will work running a vest over a ghillie, should I just ghillie up the arms and a little on the sides, leaving the middle open for the vest, or should I make a full crawl suit and just put the vest on over the jute?
The other thing is, if I'm going to sling the rifle at all, I will have to use a single point, as the forward sling mount isn't very strong. How will this work with transitioning to my planned secondary (KWA MP9R)? Should I plan on only using the MP9 when pinned down and unable to get out, in which case I wouldn't need a sling for the Crimebuster and the plan for engagement would be to drop the rifle, pull the MP9 off the weapons catch, and fire. If I got a single point sling, I could fire the MP9 while extracting, although that might not even work. What do you guys think?
Thanks for your help.
Sam
1 - 8 of 17 Posts
I would be wearing the ghillie (BDU based) and then on top of that the vest with jute/burlap/real veg. in the Molle, I would just have to pull up the material around the pouch if I wanted to remove the contents. I would probably wrap my MP9 as well, just to keep everything camouflaged.
no, it uses aluminum, that's the problem. The whole front end is attached very weakly with a small machine screw into the aluminum receiver. Why do you say I'd be screwed entering a building?
Also, 450' isn't much of an exaggeration. As I say, there have been reports of that kind of accuracy. The common standard is 350' at least, with 450 being shown in a couple different examples.
Also, 450' isn't much of an exaggeration. As I say, there have been reports of that kind of accuracy. The common standard is 350' at least, with 450 being shown in a couple different examples.
Cheese man:
Toomanybbs: The problem with a two point is that the entire front assembly is very weakly connected to the body. My problem is not if I should get a one or a two or a three point sling, it's if I should even bother with a one point at all.
My friend, Sniperwoosh, is. He actually out guns me with his Booster Crimebuster. Its a gas operated semi-auto that has some mad range and much more accuracy than I could dream of. He has confirmed one-shot kills at 450'. He had a serious elevation advantage but you should have seen the havoc we caused at Noob day. 2011, will be even better.
Those were both made by Mateba, the first one in his thread "My spotter's rifle" and the second one in the "Your longest shot" thread.At Noob Day 2010, I was getting 350+ shots from an elevated position with bursts. Of course I was spotting for Sniperwoosh, with my Asahi M60. Woosh was one-shoting people at the same distance with his custom Kokusai Crimebuster. It was pretty impressive but having a height advantage is really fortunate.
Toomanybbs: The problem with a two point is that the entire front assembly is very weakly connected to the body. My problem is not if I should get a one or a two or a three point sling, it's if I should even bother with a one point at all.
The problem with using a fobus/serpa is that I don't think they make one for a MP9. The other problem with a belt is that I'm going to need hydration, and lots of it. I'm a 6' 220# guy who'll be crawling around in a ghillie in the Georgia summer (For those of you who don't know, that means 90+ degrees and 75%+ humidity). Just another thing, my dilemma with the sling is not to infiltrate buildings as there is only one that I would need to infiltrate at my field and it's pretty small, it's for if I get smoked out of my hide to cover my advance to the rear.
Fuzzy, I realize those were with elevation, but notice that's 450' with elevation, numerous other owners on the classicairsoft forum have reported 350' flat range.
The main reason I posted this thread was to see if I was going to run into any problems with putting veg/jute on my gear. Since that question has been answered, I thank you all for the help.
Cheese Man. I'd say that in the Georgia heat I probably could do that.
The main reason I posted this thread was to see if I was going to run into any problems with putting veg/jute on my gear. Since that question has been answered, I thank you all for the help.
Cheese Man. I'd say that in the Georgia heat I probably could do that.
sorry to bring up this thread again, but I wanted to let you guys know about the theory I came up with to fix this problem.
Use Down Range Gear's ITW Nexus QASM mod: http://www.combatreadyusastore.com/itwnexusqasmquickattachsurfacemount.aspx
to connect a strip of netting the size of the vest to the vest. If I was going to roll as a DMR for a short game, I'd just unclip that and be good to go.
Use Down Range Gear's ITW Nexus QASM mod: http://www.combatreadyusastore.com/itwnexusqasmquickattachsurfacemount.aspx
to connect a strip of netting the size of the vest to the vest. If I was going to roll as a DMR for a short game, I'd just unclip that and be good to go.
1 - 8 of 17 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Airsoft Sniper Forum
A forum community dedicated to Airsoft Sniper firearm owners and enthusiasts. Come join the discussion about optics, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
Top Contributors this Month
View All
SiliconeSword
121 Replies
Leo Greer
69 Replies
Akami
56 Replies
Recommended Communities
