Airsoft Sniper Forum banner

How to get a stripped screw out of a hop-up

4243 Views 22 Replies 8 Participants Last post by  inthetallgrass
Yeah, stupid companies can't make high quality screws anymore. My PDI placement screw is stripped. How can I get this out without destroying my magwell + hop-up.
1 - 5 of 23 Posts
Will post a picture, going to try a flathead right now.
How much does a extractor bit cost? Where could I buy one?
Got it out! Flathead + A hammer. Flat head into the screw to make a flathead spot, then finally twisted it out.
1 - 5 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.