[fuzzywolly]

It is the same as for the UTG mk96 and maruzen l96. Here is a solid guide:

http://www.airsoftsniperforum.com/phpBB/phpBB3/viewtopic.php?t=1027

Any other specific questions feel free to post here.

 

[fuzzywolly]

That 650 might be a little too long, I think the stock size on the TSD ones is about 500 mm...

You are going to have to remove the end cap, as the end cap will block the chamber from aligning up correctly. Once the end cap is removed you will be able to install it just fine.

HOWEVER, now you have to get yourself a threaded adapter, and a suppressor to act as a barrel extension. Once you do that, you should be fine, as long as you make a few barrel spacers to keep that barrel from wobbling all over the place.

 

[fuzzywolly]

Ok, this is getting out of hand. Let's all settle down, and get back on topic. This is about installing the PDI chamber in the L96. NOTHING ELSE.

Otherwise the topic will be LOCKED.

To the OP, do you have any other questions relating to the topic?

 

[fuzzywolly]

Tarma, while I love a good sense of humor, lets keep this thread on topic. I will leave this open in case the OP has any other questions.