Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
34 Posts
If you are struggling with mag changes, try this.




Open up a standard TM/JG VSR mags, drill a 3mm hole carefully in each side (once you open it up you will see where i drilled through, its the only gap inside that doesnt interfere with the mag follower)

Add a piece of para cord and heat seal the ends with a lighter (this stops them coming back out of the hole)

Reassemble the mag, and you have a "Magpulled" VSR mag.

I did 4 of mine (back when i had a VSR) and 6 for a mate, all worked well, even when shooting in gloves.

Jim
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top