[flash93]

My DMR is making a loud "slapping" noise and I was wondering if a Silent Bore Up Kit would take away that "slapping" noise? If not what can?

 

[wesley810]

Go down about half way in this thread to the "Sound Proofing" part and there's also a link to some more stuff. You might find some of it useful.

http://www.airsoftsniperforum.com/phpBB/phpBB3/viewtopic.php?t=889

 

[grant23]

AM (AirsoftMechanics) did a review on these.. they just change the noise a little bit, they dont actually perform as advertised.

 

[flash93]

Does it dampen the noise?

 

[Star_folder]

Does it dampen the noise?

A little, but, they fall apart.

What you should do is add sorbo to the back of your cylinder head. It will have the same effect as the Silent cylinder set.

Also, a Bore Up kit would just make your system louder. More air = more pop at the end of the barrel.

 

[goldentrigun]

That depends on what cylinder type/ barrel length he is running. Also he could remove the pop by measuring out the volume needed inside the barrel and drilling the cylinder to be 2 times the amount needed for the barrel.

 

[flash93]

Where can I get a Sorbo pad?

 

[flash93]

Could I combine the sorbothane pad with Silent Bore Up Kit. Reason I ask is because I am also going to extend my inner barrel and add a mock supressor for accuracy.

 

[Star_folder]

Sorbopads.com is a great place to get them. Scatterplot makes some good stuff, and is a stand up guy.

And a longer barrel won't give you more accuracy, a quality barrel will.

And combining a silent head and sorbo is kind of useless, it won't be any quieter than one or the other. It would be a waste.