Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi guys. I done some searching and couldnt come up with anything.

The Hpa rifle that im working on right now has a vsr edgi 6.00 barrel thats also ported. the thing is. its also a 430mm gspec barrel. Im having to run a lot more psi than I should to get the fps where it needs to be.

Is the shorter barrel the reason? I put it in because it was something I had here. But from what ive learned so far I think it may be really holding it back. Thanks guys.
 

·
Registered
Joined
·
445 Posts
What does your rig consist of, as far as your regulator, tank, and this is not a big thing but the temperature as well.

From those I can help, also remember with a longer barrel you get more fps, what were the fps differences between the two.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Im using a Palmers Stabilizer. Im not sure of the model but I do know that its what they advertise for airsoft. So I figured it would be good. Im using a 300psi tank. Most of the time of year I play the temperature is around the 80's to mid 90's.

The Gspec 6.00 barrel is the only one that ive had in the rifle. I put it in just to try it out.
Thanks
 

·
Registered
Joined
·
445 Posts
Well with temperature you are in, it shouldn't affect the pressure of the HPA bottle. Also Im going to assume you meant a 3000psi
Also what is the FPS you are looking for, you would want a psi around 60 to 80 for some were around 450 to 550.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top