Airsoft Sniper Forum banner

Hunting for ideas and material

1852 Views 9 Replies 4 Participants Last post by  becklr1
Just thought I would mention, if you are looking for ideas, spend an hour or so in a hardware store. Not home depot a good large hardware store.

I have principle that what ever I build should be supportable with locally parts and not have to buy or make buckings or what not.

Case in point I wanted to find new material for a fixed hop up. I have some but it was not working for me. So I took a stroll through my favorite Ace Hardware.

Check this out. It is very high friction and is flat and easy to cut to length. Not sure how tough it is though but I suspect it is tough enough. You could also find super tough rubber sheets in red that is 8 inches x 8 inches and 3/16 thick and is used to make plumbing gaskets.

Sometimes material leads to ideas believe it or not.

Sorry about the lighting.


See less See more
2
1 - 2 of 10 Posts
you should soak it in kerosene and then silicone. This will soften it and stop it from drying out.. Unless you want a really hard rubber.
Just buy a rod of the same thickness and lathe it. Or for the square hole, a series of piller drill holes or a milling machine if possible.
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top