Airsoft Sniper Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,106 Posts
Discussion Starter · #1 · (Edited)
*Items in the ----- Lines are needed with each other
---------------------------------------------------------------------------------------http://www.airrattle.com/Hunterseeker-Armory-IER-Hop-Pack-2-Patches-p/ier-hop.htm

Hunter Seeker HS Armory EM-Nub - Pack of Two.
---------------------------------------------------------------------------------------

Airsoft Hunterseeker Armory IR-Hop - 3 Patches.

Airsoft Hop Up by Hunterseeker Armory M-Nub - Pack of Two.

---------------------------------------------------------------------------------------

Hunterseeker Armory ER-Hop Pack - 2 Patches.

Hunter Seeker HS Armory EM-Nub - Pack of Two.

--------------------------------------------------------------------------------------- Did any1 else know that air rattle sells HS Armory stuff? Weird. Anyways i was wondering which of these (I)(E)R Hops would fit my kjw m700. I am using a mad bull 6.03 VSR Barrel. Also do these require any mods to the barrel or gun to be installed? And how do you install it?

Edit: 1st link won't work, just copy/paste it into google
Edit2: ha title isn't suppose to be IER Hop, my bad
 

·
Registered
Joined
·
39 Posts
This must be some sort of cruel joke.

There have been 6 or 7 R-Hop related posts in the last day I think.

Don't buy from HS5. You can order from McMasterCarr, same price almost, and get 10 FEET of the material rather than two little patches.

Do yourself a favor and look at all the posts on page 1 of this section right now that regard R-Hop. Read them. Sorry if I sound insensitive. This question has been beaten to death in the last few days.
 

·
Registered
Joined
·
1,106 Posts
Discussion Starter · #4 ·

·
Registered
Joined
·
39 Posts
Wow Bobcat, that sucks to hear your experience with this kind of hop system.

Tell ya what, send me a barrel and hop unit, let me get it all set for you, free of charge, and in exchange just write a good review of my services if you like my work. Or, pull the patch out and go back to retail hop materials.

Just an offer.

I've had nothing but satisfied people when I've done installs. And I charge $50 in labor max (I have to make it worth my time, and it's never under an hour or two because I test my installs thoroughly). If you have a spare barrel and hop, send em my way man.
 

·
Registered
Joined
·
1,106 Posts
Discussion Starter · #7 ·
I have no idea about a flat hop + your custom flat nub. But I do know that using a flat hop with the STOCK nub is great. Thats what I use on my personal KJW M700.
Ok I'll try
Edit: it's pretty hard to make the bucking mound flat, any tips?
 

·
Registered
Joined
·
1,356 Posts
Turn the bucking inside out, it may be difficult but you'll find a way. Take an exacto knife and cut off the mound without cutting the bucking. Take high-grit sand paper and make it super-smooth… done. Thats what I did, and I am getting shots out to 250+ feet, accurately.

(Anywhere within 190-200 feet, my rifle is deadly. From 200-300, I feel I can no longer choose where to hit the target, and anywhere past that is just a lucky shot if it hits)

Edit: I went over the original post again, you mentioned you wanted an IER-patch, and was wondering if you needed to modify the barrel. No offense, but do you actually know what an ER-Hop is?
 
1 - 8 of 8 Posts
Top