Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
I took my tanaka m700 police version apart to check the hop up; found it was filthy from bb residue as i was putting my rifle back together i noticed the barrel wobbled a lot. i shimmed it with some electrical tape and all was well. i then put the gun back together without the outer barrel, shot it and noticed the front of my barrel was moving. when i pulled the bolt back the barrel would rise in a diagonal direction toward the right. when i pulled the trigger the barrel would fall diagonally to the left. is this supposed to happen? if not what are some solutions?

***Note when barrel wobble occurred i was dry firing the rifle
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top