Airsoft Sniper Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,893 Posts
Discussion Starter · #1 · (Edited)
I'm going to be ordering the ir-hop for my bar10 because here in NJ, it can get pretty cold sometimes. Do you think it is worth ordering the z-kit or do you think I should just get them oversized and cut for myself?
 

·
Registered
Joined
·
2,893 Posts
Discussion Starter · #3 ·
Thanks. After I cut them do I also need to sand the edges? I don't have sandpaper over 150 grit. My nail file might be though because I use it to get a razor sharp edge on my kitchen knives. Not kidding about being razor sharp either ;)
 

·
Registered
Joined
·
2,893 Posts
Discussion Starter · #5 ·
Another way to use a nail file in a way it completely wasn't made for. Thanks.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top