Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
228 Posts
I've had the same problem of the bolt being difficult to push forward in my new BAR10, it did this for a few shots then started slam-firing. I would check your piston, see if it can catch your piston sear properly. Also check your piston O-ring and spring guide stopper. Take out the piston O-ring and see if the problem still persists. I've had the bolt not going all the way forward problem, it turned out to be my spring guide stopper.

As for the bolt handle, is there a screw on the very end of it? There is one on my BAR10, and all I had to do was tighten it with an allen key.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top