Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
And assembled it after initial cleaning it, and the first time I racked the bolt it was stiff and I noticed a mangled tiny o-ring right in the breach. I removed it and the pull was perfect, and it seems to feed and shoot OK for an untuned gun. So where the heck did that o-ring come off of?!? I haven't yet started a full disassembly and full cleaning so was hoping for some insight on where to be looking to see if an o-ring is missing. Thanks guys...
 

·
Registered
Joined
·
93 Posts
Honestly the only part of the gun with any o rings is the barrel assembly. There are some in the hop up chamber, some on the spacers for the barrel, and I believe one to hold the hop up chamber in place. Where you describe finding it seems to be just one that made it's way into the gun from the factory, probably somewhere in assembly.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top