Airsoft Sniper Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
hello, I am new here and I have been researching for quite some time now, and have recently seen the king arms m150 gearbox on ehobbyasia.com(heres the link- http://shop.ehobbyasia.com/king-arms-m150-ver-ii-rear-wiring-complete-gearbox-for-m16a2-aeg.html ) So my plans would be to just "drop in" this gearbox after modifying it to be semi-auto only. Has any one ever had experience with this gearbox before, or even for that matter, dropped in an m150 before and had success?
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
So you don't think I should get the gearbox? Any ways, I think I am going to go with an a&k sr-25 instead of a normal m16 since it's gearbox design is better built to sustain higher springs.
 

·
Registered
Joined
·
354 Posts
Well king arms does make nice stuff and the specs on the gearbox seem good. Personally I would stay away from the SR-25 they have a longer piston/cylindar design so parts are not as available as a normal V2, If you want a great base for a DMR I would go with a KWA SR-12, they are a bit pricey but well worth it.
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #5 ·
Ok, thanks. I was looking to go for the "cheaper" side of making a dmr rather than spending like 500 dollars on one. i was figuring i may go with something like a dboys m16 dmr since it's full metal and is fair priced.
 

·
Premium Member
Joined
·
3,494 Posts
Welcome to the forum, Jeffrey. Please start capitalizing the letter "I" as it is part of the grammar and punctuation rule here.

Also, please make an intro post so we can get to know you.

Thanks
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top