Airsoft Sniper Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
Hey guys, so i was doing somemods to my 10/22 to try and make it more consistant than it was stock. After installing a new barrel/rubber from falcon, as well a numerous mods, i can get deviations of +/- 6 fps. I know that sounds bad, but for a gbbr, i am rather satsified with my handy work. It makes a very formidiable scout sniper/ dmr rifle now!
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #4 ·
What id did was add
Madbull steel fill valves
Ratech npas for kjw m4
Tsc steel internals
Falcon extended inner barrel
Falcon 60 degree rubber
Small mods.

Will try for more, but that is so far. Will update if it gets better!
 

·
Premium Member
Joined
·
3,434 Posts
psination said:
What id did was add
Madbull steel fill valves
Ratech npas for kjw m4
Tsc steel internals
Falcon extended inner barrel
Falcon 60 degree rubber
Small mods.

Will try for more, but that is so far. Will update if it gets better!
Please elaborate on the "small mods" portion. If you are trying to help someone else out, be more detailed. Otherwise it does us no good.
 

·
Registered
Joined
·
63 Posts
Discussion Starter · #6 ·
Sorry man!
Teflon taped the bucking
Sourced a new striker spring at the hardware store
Knocked a mm or two off the plunger
Polished the barrel,
And some other stuff i cannot rembember for the life of me. Ill check it later and try to figure out what i did. Hope this helps!

Edit-
Chronoed with my uncles chronograph.
Shots were-
515,512,510,498.490,487,487,486,485.
It setteled at 485ish, and stayed there after 5-6 shots over a peroid of 5 different mags.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top