Airsoft Sniper Forum banner

KJW M700 Takedown Upgrade Questions

4748 Views 7 Replies 5 Participants Last post by  p2skater1
Okay everyone, so I recently got my hands on a KJW M700 takedown and am looking for some upgrade advice. Firstly I will be HPA tapping it, which brings me to my first question, Im looking for 2.3j with .32g bbs at 90psi (aka 500 fps with .2's). That's the psi I run my Daytona gun at, and im wanting to run them simultaneously off the same regulator.
So my question is what is the shortest barrel length would allow me to do this (Im planning on using a 6.03 or 6.05)

Also if I do shorten the barrel will I be able to use one of these:
Steel CNC 14mm Negative Adapter for M700 Series Airsoft Sniper Rifles, Accessories & Parts, External Parts, Adapters - Evike.com Airsoft Superstore

And last one for now, are the stock KJW valve knockers made out of steel?
1 - 1 of 8 Posts
[M]y question was specifically regarding how to achieve 2.3J at 90psi (with .32's) due to me only wanting to carry one HPA tank while running my Daytona gun and M700 at the same time. Unfortunately I cant sub regulate the Daytona gun down to 90 psi while running the m700 at a higher psi due to Daytonas being total air hogs.
I find it hard to believe it's going to be easier for you to try and build a gun to achieve a precise muzzle energy at a certain input pressure, than it is for you to buy a twin regulator fitting or something.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top