Airsoft Sniper Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
well I have decided to go out on a limb and I've ordered a KJW m700 take down version however I understand there are a few problems with consistency on the stock barrel considering a 6.1

I was planning on buying

http://www.airsoftgi.com/product_info.php?products_id=6046

I also understand its compatible with some tanaka parts based on that knowledge I also planned to order

http://redwolfairsoft.com/redwolf/airsoft/ProductDetail?prodID=16361

with

http://redwolfairsoft.com/redwolf/airsoft/ProductDetail?prodID=15866

and on a side note I've heard that this gun is capable of taking the tanaka 29 round mags does anyone have some info on this?

Please feel free to input ur knowledge or make some suggestions all are much appreciated :)
 

·
Registered
Joined
·
152 Posts
I'd personally forget that barrel, and buy a decent VSR barrel because the wonderful thing about KJW M700's is that they can take VSR barrels and buckings without needing to buy a conversion chamber like the Tanaka needs.
King Arms airseal bucking for VSR works really well on the KJW, I use it in combination with a deepfire 6.02 barrel with excellent results, though I do use my Tanaka PCS bolt instead of the stock KJW bolt.
KJW long and short mags fit in Tanaka rifles, and Tanaka short mags fit in KJW rifles, but I don't have a Tanaka long mag so I can't say for sure but it makes sense that it would. Just get the KJW long mags, they're exactly the same but a bit cheaper. :)
You might need to fit an O-ring to the silencer adaptor, because the barrel dimensions are slightly different to the Tanaka, but I've got an adaptor on the way to me so I'll be able to verify that in a day or two hopefully.
 

·
Registered
Joined
·
349 Posts
Well I have a Tanaka m700 AICS. Yes I know its not a KJW but they have the same problem; consistency on propane or green gas, the consistency is terrible. If I was you, im doing this right now also, I'd spend a good amount of time looking around at how to make a co2 or HPA rig, this is the greatest fix for gas operated airsoft snipers. Also invest in a good bucking and a 6.03(not 6.01) TBB. This is just my $.02.

NOTE! I sent an email to asgi about that inner barrel you mentioned! It does not have the gruve for the VSR-10 buckings!

Go with laylax, Edgi, Prometheus, or PDI barrels that are designated TanakaM700, KJW or Vsr-10 compatible. AND DONT GET the madbull 650mm inner barrel.
 

·
Registered
Joined
·
349 Posts

·
Registered
Joined
·
205 Posts
I'm using a madbull 6.03, it stops just inside the king arms adaptor so it's probably an inch longer than the stock barrel. I also use the Tanaka long mag, it needed rubbed down with wet and dry paper to make it fit smoothly, but other than that it works fine.
 

·
Registered
Joined
·
152 Posts
I've not had a problem with mine that I couldn't fix, the stock hop up bucking was rubbish though. I'm using a King Arms Airseal rubber, and a H-nub and I'm getting some really good results. You can also get a regular M700 hop wheel and modify the receiver to allow you to use it in the takedown version, all that needs to be done is one hole drilled, which is nice and easy ;)
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top