Airsoft Sniper Forum banner

L96 trigger box question

2813 Views 6 Replies 4 Participants Last post by  Cheese Man
Ok, so I am getting a blank wooden stock for my l96. I will be cutting out all the holes and such.

I am wondering, I will need some sort of trigger guard for the gun, but on the l96 trigger, some random pin is just sticking out. Would cutting the pin off effect the performance of the gun? I know the pin is used at the TOP of the trigger box to guide the spring, so would removing the bottom end effect the gun in any way?

If you still are not sure, refer to this pic:


I want to remove the bottom portion of the set pin.

If it turns out that I cannot remove it, what would you suggest I do as a trigger guard for the gun?
See less See more
1 - 1 of 7 Posts
Yeah, you can cut that off no problem. It just means you will have to completely detach the trigger box from the receiver to take the cylinder out though.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top