[toomanybbs]

So, I have an external rig for my sniper. New rules have been introduced to my community stating that I have to have a locking system on my regulator. Could someone give me advice/ ideas on how to do this?
Thanks in advance.
Here is my regulator:

 

[toomanybbs]

How hard do you have to turn to break blue loctite?

 

[toomanybbs]

I emailed palmers, all the said was "If you have a rock knob just remove it and replace it with a screw".

 

[toomanybbs]

IOf course a nut on the new set screw could be used as a jam-nut which would be just as good as any tourny lock. You would need two tools and more TE paint to change you reg.

Jam nut, please explain more!

 

[toomanybbs]

Take a nut that threads on the new set screw and use a wrench to get it more than hand tight. This will prevent the set screw from going any further into the reg without taking the nut off first. Use a little thread paint for obvious reasons and I don't think an OP host would have a problem. At least you took the time to put up with their hassle. They treating other GBBR and PTW users the same?

HPA GBBR yes, PTW maybe? But the new product that has the adjustable piston is not allowed.

Wouldn'y just be able to screw the bolt all the way over the set screw, like it wouldn't stop tightening?