Airsoft Sniper Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
I have a PDI hopup chamber for my L96, the one with the minuscule hex screws in the base of it. Anyway, I lost the allen wrench that came with it, and haven't been able to find one that fits. I bought a kit from Home Depot with sizes that ranged from 10 mm down to 1.5 and the 1.5 was still a bit too large. Does anybody know what size these things are and where i can get another one? Your help is appreciated.

Happy Hunting
 

·
Registered
Joined
·
951 Posts
I used a torx wrench (cant remember what size).

This was one with a screw-driver-like design, so I dont have to fiddle with the small hex screw. It makes finetuning much easier. Just be carefull not to strip the screw though.
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #4 ·
Is there a dealer in the US, or just not Hong Kong that sells the repair kit? Airsoft atlanta is out of stock and I think there are trade sanctions in the US preventing direct purchases from China, ironically.
 

·
Registered
Joined
·
951 Posts
Crap, ok wait sorry, overlooked that you had a PDI hopup unit. Then its a M1.0 Their a bit harder to find. However, if you buy a torx set, i think the smallest one will fit. (cant remember what size it was)
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top