Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
951 Posts
I used a torx wrench (cant remember what size).

This was one with a screw-driver-like design, so I dont have to fiddle with the small hex screw. It makes finetuning much easier. Just be carefull not to strip the screw though.
 

·
Registered
Joined
·
951 Posts
Crap, ok wait sorry, overlooked that you had a PDI hopup unit. Then its a M1.0 Their a bit harder to find. However, if you buy a torx set, i think the smallest one will fit. (cant remember what size it was)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top