Airsoft Sniper Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hey Folks,

I have an MLC338 and I really like it. Although its fine for most big games I play, the local pick-up field has a limit of 1.5 Joules. (400 FPS with .2s, 360 FPS with .25s, 330 FPS with .3s).
Obviously, the stock spring is pretty hot. I cant seem to find a low enough power spring. I tried a PDI that was rated to 370, but it didn't fit the cylinder. I was hoping you guys may be able to help me to find an 11mm spring that would be within the limits.

Any recommendations would be appreciated.
 

·
Registered
Joined
·
2,126 Posts

·
Registered
Joined
·
2,126 Posts
Then just wrap your piston in copper wire, golfers tape, or solder, and put some painters tape and hot glue on top to keep it secure.
This should drop a good deal of FPS.

Cutting springs is usually the last resort, but weighting a piston is the next best thing to buying the correct spring.
 
1 - 9 of 9 Posts
Top