Airsoft Sniper Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter · #1 ·
I have had a noobie's m-trigger for a long time now, (back when my m40a3 was just a cute R700) but now its starting to feel like it's wanting to slamfire. Has anyone ever had this happen with their m-trigger? I know the trigger is made out of steel, but at one point in time i had the SS5000 spring in my gun. I think that the SS500 along with the old age is finally getting To it. What do you think? And if you're wondering about the symptoms, its small things like when i cock the rifle, it will catch. The only thing is: when i start to push the bolt back in, it will jerk forward.
 

·
Registered
Joined
·
1,159 Posts
How often do you take apart and clean/grease your trigger unit?
What condition are all the pieces in?

It may be time to replace your sears and springs!
 

·
Registered
Joined
·
52 Posts
Discussion Starter · #4 ·
The m-trigger doesnt use springs, it uses magnets. And also the piston I am using is a pdi 90 degree piston. I just cleaned the sear, so if you are correct, I need a new one. The only question is would I have to buy a new trigger? Or could I contact noobie for a new sear?
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top