Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hello, I recently bought a used M24 as my first sniper rifle and I love everything about it. Unfortunately, it has succumbed to what I am told is a common problem: the receiver screw holes have stripped.

My question is two part. First, what diameter am I aiming for when I retap the hole and two (and most importantly) what tools do I need to accomplish this feat?

I have seen many youtube videos and I am confident this procedure is one I can accomplish, I just need to get the logistics down first.

Thanks a lot,
Gunslinger
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top