Airsoft Sniper Forum banner

M700 and Bar10

4125 Views 9 Replies 7 Participants Last post by  silentfury214
First is my KJW M700 rifle.
It's a nice rifle, looks and shoots good, very quiet.

I've hit targets at approx. 220 ft with no problem with .30g Madbull bb's & .28g Elite. Chrono's in about 430fps with those heavier bb's
Rifle has a 6.03mm, 650mm Madbull innerbarrel, two working gas mags, custom V nub, 3-9 x 40 scope, harris-style bipod, mock silencer.

Older photos of the same rifle:

I'm probably going to sell this rifle. Mainly because it doesn't suit my playing style. I think I'm going to get a slightly upgraded VSR style rifle for plinking and occasional game.
I think this KJW would be incredible with an external, regulated airsource. It already shoots really well, just imagine with
a few mods. I have some locals interested in it...see if I can sell her at the next big op.
Some are encouraging me to keep, but if I continue sniping, I just want a simplier, shorter rifle and stalk more than sit and shoot.
I guess be more of a marksman.

The next rifle is my old Bar10. I enjoyed it. Had a M190 spring in it. Was my first airsoft rifle, so I really did under estimate it's power. Fortunately enough I never shot someone with in 100 feet with it. I dropped it down to M170...
full Laylax internals and a 303mm PDI barrel.

I sold her to check out gas rifles, since I use to play paintball for years, I was very familiar with HPA set ups and had all the parts to run an external airsource.

See less See more
1 - 1 of 10 Posts
I would love too know more!

I have been looking into HPA/Co2 rigs for awhile, there is one thing that I have never found when I searched though. How does the HPA effect the barrel in terms of rusting or anything of that sort? Should I be more cautious with my barrels when using an HPA rig? Also I know you said it takes 5 minutes too break down a mag if it needs too be lubed, where should I lube the mag exactly? I know that the O rings would be a good start, but any other important places?

Beautiful rifles man! I assume you did this with an airbursh? Great work on both of the rifles!

See less See more
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.