Airsoft Sniper Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 · (Edited)
Hello I have been thinking of a way to fully load my kjw M700 with out having to take to magazine out and not doing it one by one. I just cant seem to think of any ways to do it other then a small tube with a slight bend in it.

I have been searching the internet for a few hours now but cant come up with anything.

Does anyone know of any place that has a "how to" for loading your m700 with the mag still on?


Thanks
 

·
Registered
Joined
·
140 Posts
Gas rifle(G&G G96/Tanaka)? pull the bolt back, slide a BB into the mag feed lip. I do it all the time.

If it's a springer I have no idea.
 

·
Registered
Joined
·
909 Posts
Maybe you could fashion some sort of tube that attaches to a speed loader so that you can just pull the bolt back and load the whole magazine. It would be tricky, but could probably be done (a lot better than loading one by one). Why don't you want to take the magazine out to load it?
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #4 ·
just thinking that if I can load it with out taking the mag out i might be able to some how run the HPA/co2 rig 100% internally.

Of course getting the airline from the stock past the trigger assembly to the mag will be another problem. And then figuring how to attach the airline to the Mag will be another thing to overcome as regular fittings are too big
 

·
Registered
Joined
·
909 Posts
just thinking that if I can load it with out taking the mag out i might be able to some how run the HPA/co2 rig 100% internally.

Of course getting the airline from the stock past the trigger assembly to the mag will be another problem. And then figuring how to attach the airline to the Mag will be another thing to overcome as regular fittings are too big
You would still have to have a small macro-line come out of the stock and attach to the bottom of the magazine. That would still leave room to take the mag out.
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #8 ·
You could mod the mag to look like the Ares mags ... I mean to have a strip and remove that separately leaving the mag on the gun..
I do like that idea Wolf thanks
It gives me a few more ideas.

You would still have to have a small macro-line come out of the stock and attach to the bottom of the magazine. That would still leave room to take the mag out.
I am actually trying to think of a way to connect the mag to the airline from inside the gun. That is what makes it more tricky. Trying to have no hoses show on the outside.

I do have a lot more room on the mag if i upgrade to the G&G knock arm and plunge set. Cause i don't need the mag release if i dont plan on taking the mag out. If i do as wolf pointed out some how mod my magazine then I would have 2 parts. 1 A BB magazine which holds the BB's. 2 A Expansion/Gas holding area. So now once i have the expansion/gas holding part of my mag installed and hooked up to the internal line there should be no reason i need to remove that part unless it requires maintenance.

Hmmm oh how the ideas are flowing in my head right now.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top