Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
346 Posts
Discussion Starter · #1 ·
I've installed a DBC 6.01/509 mm tightbore, pdi hop up, and hard type madbull/systema buckings in my UTG type 96. I caniballized an old cylinder set
 

·
Registered
Joined
·
346 Posts
Discussion Starter · #3 ·
Ah okay...I've run a few hundred rounds through it, I'll do a proper break in

I think the bucking is most likely the major culprit, as I was getting NO hop...it wasn't an accuracy issue

Anyway, the new Maruzen (type 96) arrived today, and I'm currently installing the new items
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top