Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Will these work for the aps2 sv? I will be useing all thease togather.
PDI Laser-Cut High Precision Cylinder Set Lv3 (With Vacuum Piston) for Maruzen APS2.
PDI Reinforced Trigger Sear for Maruzen APS2.
PSS2 Piston Sear for APS2.
PDI HOP-UP Chamber for Maruzen APS2.
PDI Reinforced SET PIN (TIGHT) for Maruzen APS2 OR/SV/EX.
(Maybe)PDI Short Stroke Cylinder Head for APS2.
PDI Remington Type Receiver for Maruzen APS2.
PSS2 APS2 Bolt Handle (Right Hand Use) OR Guarder Steel Bolt Handle for APS-2 OR / SV. IS THIS RIGHT HANDED ?
PDI SPR 250% Spring 13mm diameter & 11mm inner diameter.

WILL THESE WORK TOGETHER ???
 

·
Premium Member
Joined
·
716 Posts
Yup, they'll all work together. The Guarder handle is right handed as well. I'd recommend going with the Guarder since it's cheaper. They're the same build quality, but I prefer my Guarder over my FF handle because of the texture on it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top