Joined
·
349 Posts
So I was modding my inner barrel according to this guide:
http://www.airsoftsniperforum.com/phpBB/phpBB3/viewtopic.php?t=1235
so I could fit a nine ball bucking on it. I accidently cut to deep on one part and I made a hole that goes into the barrel its about .5mmx.2mm. If I cover it with electrical tape, then the bucking, then tie the bucking with floss do you think this will keep the gas from escaping through the hole. Or have I just destroyed the inner barrel?
Thnx in advance,
Mike
http://www.airsoftsniperforum.com/phpBB/phpBB3/viewtopic.php?t=1235
so I could fit a nine ball bucking on it. I accidently cut to deep on one part and I made a hole that goes into the barrel its about .5mmx.2mm. If I cover it with electrical tape, then the bucking, then tie the bucking with floss do you think this will keep the gas from escaping through the hole. Or have I just destroyed the inner barrel?
Thnx in advance,
Mike