Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
109 Posts
Acetone or Methyl Ethyl Ketone (MEK), it will craze the plastic (It works by chemically melting the 2 parts of plastic together) if your not careful, so dont be over zealous with it.

Use some sand paper to rough up the surfaces you want to glue and apply. The strength of the bond in regard to what strain you put on it will depend on how big of a piece you are gluing, I mean the surface area that the glue is applied to. Ummm Im not sure about the gel glue that comes in a tube, but the liquid glue for plastic models with the brush applicator from Testors is what your looking for.
 

·
Registered
Joined
·
109 Posts
MEK is best, if you can find it you can use a pencil sharpener to run a rod of ABS through to make shavings, mix that in a 50/50 ratio with the MEK and make a "welding paste" I do that for some of my modelling work.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top