Airsoft Sniper Forum banner
1 - 8 of 8 Posts

goldentrigun

· Registered
Joined
·
890 Posts
Discussion starter · #1 · (Edited)
Since I just acquired a few firearms within the past month or so I figured I would post a little "arsenal" photo of sorts.

First up my newly acquired finnish mosin nagant tikka.
Image

Image


Next is my marlin .22wmr which is sitting next to my mosin for size comparison.
Image


After that comes my Mossberg rebrand 12 gauge BOLT action shotgun with selectable choke (middle).
Image


Finally, my glock 17 gen 4 9mm
Image


Any questions???
 
I don't own a Glock, let alone a Gen4, but from what the internet tell me they need to be kept lubed up pretty good.

Anywho, are you planning on doing anything to the Mosin or are you going to leave it be?
 
Discussion starter · #4 · (Edited)
I'm planning on maybe making a scout rifle out of the mosin. They sell a sight base which replaces the original rear iron sight post (drive out the pin and put in the weaver rail). This way if I decide I want to go back to the original I can easily.

Other then that I might get a "bent" bolt handle assembly in case I want to run a long eye relief scope. I want to keep it as authentic as possible so everything I do I want it to be reversible.

As for the gen4 glock. I haven't had any issues with it. Early gen 4s had the jamming issue and glock issued a spring guide swap program for certain batches. I haven't lubed it since I got it and it still runs fine. (I did clean out the barrel and wipe down the outside of the slide.)
I'll be able to say for sure when I put at least 300 through it though. I want to get adjustable sights though because I have to aim about 1ft below the target.
 
1 - 8 of 8 Posts