Joined
·
362 Posts
My Socom gear r700 is different form the rest. Mine doesn't have a pin to tap or drill out on the cylinder. It is all just one solid piece. Can they be separated? Has anyone else had this problem?
My sg R700 is different
1 - 12 of 12 Posts
Joined
·
1,103 Posts
What do you want separated from the cylinder?
Joined
·
362 Posts
The cylinder head. If I take it off I can then take out the weights and the FPS will boost by a good 50.
Joined
·
1,103 Posts
Can you post a pic because I cannot figure out what the heck you are talking about. Don't worry, it is not you, I have just not seen this particular gun before.
Joined
·
19 Posts
Maybe there isn't any pin to drill out and you should just be able to take the cylinder head off by wraping electrical tape around the nozzel and taking a pair of plyiers to unscrew it.
Joined
·
19 Posts
I just got my Socom Gear m700 and my cylinder was the same way. The cylinder head is glued on i was able to get it off but it was hard.
Joined
·
1,103 Posts
If it is glued, take a hairdryer to it to melt the glue.
Joined
·
3,494 Posts
You have been a member here for awhile now. I have looked through all your posts, and you obviously are disregarding the grammar/punctuation rule.airsoftsniper234 said:
You have received your first warning.
Joined
·
362 Posts
Ok, I would show you pics but I'm not computer savy and I can't seem to find a way to crop down the pics. I have fixed the problem though, the cylinder head was lock tighted and you have to use EXTREME force to get it out or you can melt it with a hairdryer or torch(This is what I did). But after I had taken it out I found that I melted part of my piston in the process so I had to buy a new one. I bought a Polar Star piston along with a new spring and spring guide. Also, I'm having some trouble with my hop-up, when I cock my rifle and that hop-up is off, the BB rolls down the barrel, but when I turn it all the way up it doesn't do this. My FPS has also dropped drastically even with a new spring, piston, and guide. It dropped so much I think it is lower than the 280 FPS I got it with.
Joined
·
1,103 Posts
You need to replace the hop-up bucking most likely. It seems that you are loosing tons of compression and because the bb is just rolling down the barrel, it is obviously the problem.
Joined
·
362 Posts
Man that sucks, I was hoping to never touch the hop-up until I get more experience. Does anyone know a thread about taking apart the hop-up, the SG's R700 barrel is tapered and It just won't come out. Do I have to unscrew every screw I see or what?
Joined
·
1,103 Posts
There are probably tons on youtube.
1 - 12 of 12 Posts
Join the discussion
