Airsoft Sniper Forum banner

My VSR scout rifle

4260 Views 10 Replies 4 Participants Last post by  Cheese Man
Hi guys, a while back, I decided to build a vsr scout rifle. This is my progress so far.
My almost complete vsr g-spec scout rifle

Laylax 430mm barrel
Nineball purple bucking
Laylax SP170 or SP150 spring (different fields have different fps maximums)
Laylax Zero Trigger and Piston
Laylax spring guide

RS Remington 700 sights
NCStar 2.5x20 scope

Wave 2 upgrades:
Laylax G-spec barrel spacers
Laylax Cylinder head with damping kit
Cheek riser

Since the silencer is going to be permanent, any opinions on the color? I'm leaning towards the green to contrast, but tan would keep the barrel area consistent. While the spring pull is pretty hard on the 170, would the teflon cylinder help that much? Any feedback of what i'm doing right/wrong?
See less See more
1 - 3 of 11 Posts
I like my ported barrel, but only do it if you have a drill press or a mill to make sure the holes are perfectly straight, and something to deburr nicely.
I put it into my lathe and used some sandpaper, then polishing compound on a wire brush, then a cloth.

I didn't see hugely amazing performance gains, I did notice that I could use a shorter barrel with a longer cylinder because it would decrease the turbulence at the end of the barrel. I also noticed that if you put some foam around the ports, it can act as an integral suppressor, depending on how many ports you put in.
1 - 3 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.