Airsoft Sniper Forum banner
1 - 2 of 11 Posts

· Registered
1,033 Posts
Looks very good. Replace your front cylinder guide ring (the black rings inside your receiver that you cylinder rides on, is found between the outer barrel and receiver) with medium thick o-rings, and grease that and the outside of the cylinder with WHITE lithium grease, and the bull and push of your bott will be very smooth.

I would also tone the spring down and try to get a 100% airseal on your cylinder head and bucking. Have you tapered your cylinder head? I wrote a guide on it, let me see if I can dig it up.

Found it:
1 - 2 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.