Airsoft Sniper Forum banner
1 - 6 of 6 Posts

·
Registered
JG BAR10
Joined
·
25 Posts
Discussion Starter · #1 · (Edited)
Hello guys! I´m buying a maple leaf autobot with an AA hop up chamber + ml omega nub. What Degree should i pick?
My sniper is around 2.8j with 0.45
560 - 550 fps with 0.2

Thanks!
 

·
Registered
JG BAR10
Joined
·
25 Posts
Discussion Starter · #8 ·
For the 2021 buckings I recommend 70°-85°.

For the nub, I suggest that you make the one in my signature as it's as good as the Masada arm but retains the use of the return spring in an AA chamber, and costs about $5 to make 100 of them.
Am i gonna see a difference between 70° - 85°? Or it's more about durability?
 

·
Registered
JG BAR10
Joined
·
25 Posts
Discussion Starter · #11 ·
You need to figure out which bb weight you will be using
The degrees is based on speed, and not joule rating

A .45 at 2.8 Joules is ~110m/s which is 60 degrees
A .20 at 2.8 Joules is ~165m/s which is 80+ degrees

If you're going sniper, you likely should be using .45...therefore a 60 degree
Thank you for the explanation! I am going to use .45 The idea is make it to 3.1 - 3.2 joules (Limit 3.3j in Argentina)
2.8 joules was before with stock hop up chamber + home made r-hop. I think it will go up a bit. Going to try 70° first and see how it performs.
 

·
Registered
JG BAR10
Joined
·
25 Posts
Discussion Starter · #12 ·
I really haven't seen a performance difference between 60° and 80° regular buckings when it came to the older Maple Leaf ones, but 50° sucked the most even at low power.
I like 70°, but I'm gonna buy an 85° since I tried one and liked it exactly as much, but it won't wear out as fast.
70° 2021 will be difficult to wear out, but 85-° should be immortal.
Hahah ok thank you! Think i´m going for the 70° and see how it perform! Hope to reach 3 joules!
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top