Airsoft Sniper Forum banner


1256 Views 14 Replies 5 Participants Last post by  nelsonho396
Not really dmr but I NEED HELP. Okay I have a vfc gearbox okay I just got a brand new motor the Matrix high torque long type. It pulls the spring all the way back. But as the TM eg1000 did it gets locked and stuck in the back. I can still pull the trigger but it will go back and go back to same stop and not move. Basicaly the gun won`t cycle need help please and fast.
1 - 4 of 15 Posts
Are there any bearings or anything on the spring guide or piston that may stop it from going any further?
Why don't you try to take one set of bearings out then try it?
Try counting the teeth first, the piston and sector gear should have the same amount of teeth.
1 - 4 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.