Airsoft Sniper Forum banner

Need Help Understanding Internals.

1864 Views 3 Replies 4 Participants Last post by  mroverkill
So I have my L96 and reading around the forums and with help from many of the members I no know my gun inside and out. I have recently been looking into gas and I was planning on getting a m700. Not Tanaka, but a clone. The only problem is that I have never owned or used a gas rifle, so I do not know any of the internals. I want to learn more about the internals of a gas rifle, so I am going to link some products off of AGI and if anyone could explain what they do for the gun, that would be amazing.
These pieces, from what I read, go into the back of your bolt. They strike the part on your magazine releasing some gas to shoot the BB. Does this increase the consistency of the gas usage of the magazine?
I am assuming that these help keep the flow of gas in the gun and prevent leaking of some sort. But you know what they say about when you assume.
I have no idea what this is at all. What does it do?

Those products are what I have no idea about, except for the first one. Most of the other ones on AGI I can sort of guess where they go. Any help on the internals of the M700 would be amazing.

1 - 1 of 4 Posts
I apologize for the slight necropost, but there is a step missing in that thread. Between when the striker hits the mag, there is a piece. G&G calls it a Valve Knocker the cocking piece in the bolt gets caught on a sear on the shooter side of this piece. When you pull the trigger, this sear drops and allows the spring loaded piece in the bolt to slide by. The spring loaded piece in the bolt hits this valve knocker, the valve knocker then impacts the strike face on the mag. This occurs between steps 1 and 2

I apologize again, but when giving a detailed guide like this, it should include the interface step.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.