Airsoft Sniper Forum banner

Need some long range help (APS-2)

3531 Views 18 Replies 7 Participants Last post by  aydonmill
Well, I've been out of the game for quite some time. I'm re-kindling the fire of Airsoft Sniping now out in California and well. I'm having something of a problem here. The problem being that I have incredibly low power it seems long range. I'm lucky to get maybe 20-30 feet before the hop up almost shoots it down. I've tried adjusting in large increments both ways and have yet to receive any justice to the problem at hand.

Here's what I'm shooting, essentially:
- Laylax APS Cylinder
- Laylax APS Piston & Piston head
- Laylax APS Taper Cylinder Head
- Laylax APS Spring Guide
- Laylax Reinforced Bolt Handle
- Laylax PSS2 Zero Trigger
- Laylax Power Accuracy Cup
- 400mm 6.01 Edgi Barrel Ported
- Promethues red Hard bucking
- Big-out H nub
- Laylax 150 spring (About 500FPS)
- PSS2 Aero Chamber

Long story short it's got the upgrades, almost $1000+ worth, but I'm not getting desired range right now. Or any for that matter.

I've also got a PDI Hop up at my disposal here that I could try and switch out, but I don't think it's the hop up unit itself, maybe just an adjustment I might have done incorrectly. Worst case scenario I take it to Airsoft extreme in San Diego and they charge me some rediculas rate and tell me more is wrong with it than it really is and I walk away mad but with a working weapon.

Thanks again for any help I can get here,
1 - 2 of 19 Posts
When I changed to my PDI chamber I found out why my stock hop-up wasn't working... The hop-up arm clean snapped in half, this could be why the hop-up doesnt work.
1 - 2 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.