Airsoft Sniper Forum banner

Nerf Dart Foam Hop-up Nub Tutorial?

5K views 15 replies 5 participants last post by  solarisjock 
It's really a trial and error sort of thing depending on the kind of AEG/BASR you have. Start with a large piece roughly double the size of your current rubber nub in length, but same size in width. Double the size because the force it takes to compress the Nerf foam compared to the rubber nub is substantially lower. Anyways, once you do that, you need either A) fit it to your hop up arm like the existing nub by putting it in the small u-shaped holder, or B) shave the u-shaped holder off and glue it directly to the hop up arm itself. I chose A. Your best bet is to talk to Cheese for his feedback on what is easier.
 
Yeah man, you're essentially replacing the nub which is rubber that can only bend in one direction, to a foam that can bend in multiple directions. Think of a spring mattress for your bed, versus a memory foam. It contours to the bb better at the hop up.
 
I don't know the size of that hopup nub, or if it is the same as all others. but, if I were to attempt to get the correct dimensions... A cylinder shape where the width is about double the size of it's diameter.

If you hate math, my best advice would be the stock nub can be measured if you look at the hopup arm. It should not extend past the width of the 'c' shape in the plastic. Also, it will extend exactly double the volume of the 'c' shape. If you need a diagram, let me know, I can draw something in paint for you.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top