Airsoft Sniper Forum banner
1 - 14 of 14 Posts

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #1 ·
I got rid of the TS and followed Echo's painting guide (which was well written by the way), And here are my results. I which it was more green looking, but I'll get over it. Also, sorry for the horrid Phone pictures, thats all I have for a camera.







Edit: Wow, those pictures SUCK.
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #3 ·
Ct Man said:
Looks pretty good. If you want more green, Put another layer on top. A paintjob is never done. Also, What are you running internally?
I was thing about it, but Im going to use it as is for now, ad if i feel the dire need ill add more.

for the insides:
PDI: Spring guide, trigger & piston sears, 250% SPR spring, HD piston, FireFly bucking and a KM HEAD barrel. As well as the normal DIY stuff. Shoots very nice. I get about 250ft of range.
 

·
Registered
Joined
·
283 Posts
Looks nice, What is the inner diameter of that KM head barrel? And what is the legnth? I was looking into one of these but didnt know if it was worth picking up. THere are two KM head barrels, One that is teflon coated and one that is stainless.

Also, with the PDI HD piston, You're losing alot of compression. If you get the raven cylinder set, the piston will fit alot more snug into the cylinder.
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #5 ·
Ct Man said:
Looks nice, What is the inner diameter of that KM head barrel? And what is the legnth? I was looking into one of these but didnt know if it was worth picking up. THere are two KM head barrels, One that is teflon coated and one that is stainless.

Also, with the PDI HD piston, You're losing alot of compression. If you get the raven cylinder set, the piston will fit alot more snug into the cylinder.
Pretty sure it a 6.03, and i bought it a 430mm, then cut it down to a 303mm, which wasn't that hard.

Really? Weird. If I have a 100% compression on the cylinder. huh. I would, but u just bout a new side arm. Damn xD
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #9 ·
Ct Man said:
Yeah, just making sure bud. And hows the groupings with that barrel?
For the $50 I paid for it, I get great groupings at 100'. I have yet to actually measure them though...

I be back in a bit, Im going to go shoot some 8.5x11!
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #11 ·
Test results at this time are... N/A.

Too windy to actually get good results. Along with the fact that in the first five rounds my piston end came unscrewed inside the cylinder... ::)
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #13 ·
Ct Man said:
Darn, Teflon it up bro!
I took some blue locktight to it. xD

While i have my rifle in pieces, i suppose ill take a whack at the DIY TDC kit that Gorem posted. Just gotta find my epoxy and some hardware....
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top