Hi there,
I just bought a brand new TM-VSR10 and a Taring Carving stock. The new gun works great, but when I take it out of its old stock and put it in it's new one, it won't fit.
I can slide it in most of the way, but on the receiver end of the rifle it seems to stop sliding in about 2mm away from where it should sit flush. I even tried to screw the bolts back in so secure the receiver and outer barrel to the stock, but the back receiver bolt won't even screw in due to not reaching its hole.
My question is, which part of the receiver should I sand? I already sanded where the back end of the reciver should go, and where the hop block is. Still no luck.
Any suggestions?
I just bought a brand new TM-VSR10 and a Taring Carving stock. The new gun works great, but when I take it out of its old stock and put it in it's new one, it won't fit.
I can slide it in most of the way, but on the receiver end of the rifle it seems to stop sliding in about 2mm away from where it should sit flush. I even tried to screw the bolts back in so secure the receiver and outer barrel to the stock, but the back receiver bolt won't even screw in due to not reaching its hole.
My question is, which part of the receiver should I sand? I already sanded where the back end of the reciver should go, and where the hop block is. Still no luck.
Any suggestions?