Airsoft Sniper Forum banner
1 - 6 of 6 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
Hello Snipers, I recently joined the ranks and thought it best to see what i can learn from people who have been doing it longer than me (which would be almost everyone since NAE13 was when I 1st had a go at the role). I've been airsofting since March '12 and I had had most of the bits I wanted to upgrade my A&K Dragunov for a while, but just hadn't got around to fitting them, so it was a bit of a leap of faith to take it all the way from Nottingham to Ringwood with me, but it turned out ok - I enjoyed myself and managed a few hits, even though only 2 of my targets actually took their hits lol!

Ex Two-Tone - 492-3FPS w/ 0.2g BB's / I use 0.3g Blaster Devils Advanced Hop Unit
Madbull 590x6.01mm barrel
Prometheus Purple Hop Rubber
Steel Trigger Sear
Lees Precision Engineering O-Ring
Gucci Teflon Grease
Element M135 Spring
ASPUK Extended Cocking Handle
ACM Steel SVD Bipod
Custom Fitted Ergonomic Rear Hand Grip
Custom Sticky Butt Pad
Custom CYMA Side Mount for Scope
AIM 4x32 Illuminated Scope
3x A&K MidCaps 1x HiCap
RS Soviet Era SVD Mag Pouch
RS AK Sling

Sidearm= JG Vz61 Skorpion 320-ish FPS
PDI 127x6.01mm Barrel
Orig. 80rd Box HiCap, 2 x Well 39rnd LoCaps, 1 x Well 360rnd Drum Mag
RS Czech Police Leather Holster & Mag Pouch - Customised & Dyed Chocolate Brown to match Soviet Gear

KLMK Two-Piece + home made (not so practical) Veil

In the pipeline is a LiPo & Deans conversion for the Vz61 and the agenda calls for a Steel Reinforced Piston for the SVD soon-ish and I may buy an Advanced Barrel Base Assembly at the same time to save on shipping later. Dunno yet...

Anyway, see you around the place :)
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.