Airsoft Sniper Forum banner
1 - 20 of 44 Posts

·
Registered
Joined
·
213 Posts
Discussion Starter · #1 · (Edited)
Its quite a time when I started to think about this rifle. Its young rifle. So I started to model it in 3D. They just looking for a final design of rifle , so I redraw my model every-time when they make some modification. They don't make much significant changes in last time. I hope its right time to make it in real.

Here is what I have done in 3D. Drawn from pictures, videos.






Here is what I have physically. Everything is 3D printed for test, prototype and mold use. In final stock will be plastic/metal and upper body from 6063 ALU.















Update with some new photo 10/12/2014

Some new material to work on




I am planing to make the most of small parts this winter. Also ALU parts.
With stock will probably wait until end of winter.
 

·
Registered
Joined
·
856 Posts
Damn! That is wicked! Can't wait to see more Springer
 

·
Registered
Joined
·
1,106 Posts
All the "old people" seem to be getting more active on the forums :)
 

·
Registered
Joined
·
499 Posts
Excellent work springer. I actually saw you 3d model a while back and have been thinking about making of orsist t-5000 as well. Really excited to see your design finally coming alive.
 

·
Registered
Joined
·
239 Posts
I would be happy with that plastic 3D stock as it is. I think you should sell 3D printed VSR stocks I would so get one. You would make a killing here. Nice work keep it up.
 
  • Like
Reactions: ~Ranger~

·
Registered
Joined
·
213 Posts
Discussion Starter · #9 ·
I would be happy with that plastic 3D stock as it is. I think you should sell 3D printed VSR stocks I would so get one. You would make a killing here. Nice work keep it up.
These prints, what I got now are not so structurally strong. They are printed only with 10-15 % infill. You know , if I print it as a solid it will spend 1 day + to the end ( one bigger part of stock ). I'm open to suggestions , But I think best way is print it weaker and faster. Than make a MOLD and cast it.
 

·
Registered
Joined
·
239 Posts
What material would you cast the body with?
 
1 - 20 of 44 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top