Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #1 ·
Hello,

I recently installed a new set of internals (AA Z-Trigger, cylinder, spring guide, m150 spring; 60° Autobot and Omega Tensioner) and even with the chamber on the lowest setting, I am still really over-hopping my G&G .33's.

Has anyone else had this issue with the Omega tensioner? I got it because my eraser nubs weren't very consistent and I didn't want to file down the arm on the chamber to get them thicker. Ideally, I wouldn't get any hop when the screw is all the way loose.

Thanks for any help!
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #4 ·
I'm trying to cut back the fps to 440 for one field's regulation, and I appreciate how much hop I'm getting, but I still want the option to not overhop anything under .4s

Sent from my XT1254 using Tapatalk
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top