Airsoft Sniper Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
About a week ago, I finally recieved my PDI hop up for my CA M24 from Redwolf Airsoft. After about a half hour to an hour after school every day, it still is not impressing me. The shots are relatively centered, but one shot will go dead center; the next will go wide left, the next slightly right, and the next dead straight again. I have the following installed: Madbull 6.03 Version II tightbore, Bravo seventy degree bucking, and I'm using bioval .3g bbs. (These aren't all my upgrades, just the upgrades I feel relative). I have a Laylax SP170 installed as well. I have a feeling I just shouldn't have listened to the employee at Precision, and I should have gone with the silicone hop up instead of the bravo. Any suggestions on how to solve this issue?
 

·
Registered
Joined
·
209 Posts
The PDI chamber is a fine chamber. And with a good bucking, its amazingly accurate.

I would suggest the PDI bucking, although I havent personally tried it, hey its made by PDI, and they made the chamber.

I personally have a firefly bucking in my PDI, and my little ASR is tagging accuratly (torso hits) out to about 250 ft.

In my Well G96D, I have put a hard bucking with no good results. The gun is shooting 577 fps on Propane. I put a Systema bucking that I got off of Ebay for like 7$ and BANGO its spot on out to about 200 - 240 ft. Good results with very little cash out put.

So ya, a soft bucking is fine with a hard hitting gun.
 

·
Registered
Joined
·
66 Posts
cpdes said:
I'm a total idiot when it comes to aeg buckings. Could you reccommend a good soft bucking? I have an oppourtunity foa a kwa 2gx bucking. Would this work?
i've got a firefly hopup in my vsr laylax airseal chamber
BEST in my mind :)
not to hard, and not to soft :)
just right, and got it from uncompany.com !
 

·
Premium Member
Joined
·
3,434 Posts
patriot said:
cpdes said:
I'm a total idiot when it comes to aeg buckings. Could you reccommend a good soft bucking? I have an oppourtunity foa a kwa 2gx bucking. Would this work?
i've got a firefly hopup in my vsr laylax airseal chamber
BEST in my mind :)
not to hard, and not to soft :)
just right, and got it from uncompany.com !
Grammar and punctuation...Come up pat, you have been here for awhile now. ;)
 

·
Registered
Joined
·
268 Posts
The W-hold bucking from PDI is pretty good, if alligned and set correctly this one works wonders :)
Adjusting the hop up has better effect on this one since both sides of the W really move indepent from each other.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top